Nissan Sentra Service Manual: Diagnosis system (bcm) (with intelligent key system)

Nissan Sentra Service Manual / Driver information & multimedia / Warning chime system / System description / Diagnosis system (bcm) (with intelligent key system)

Common item

Common item : consult function (bcm - common item)

APPLICATION ITEM

CONSULT performs the following functions via CAN communication with BCM.

Direct Diagnostic Mode	Description
ECU identification	The BCM part number is displayed.
Self Diagnostic Result	The BCM self diagnostic results are displayed.
Data Monitor	The BCM input/output data is displayed in real time.
Active Test	The BCM activates outputs to test components.
Work support	The settings for BCM functions can be changed.
Configuration	The vehicle specification can be read and saved. The vehicle specification can be written when replacing BCM.
CAN DIAG SUPPORT MNTR	The result of transmit/receive diagnosis of CAN communication is displayed.

SYSTEM APPLICATION

BCM can perform the following functions.

Buzzer

Buzzer

Buzzer : consult function (bcm - buzzer)

DATA MONITOR

ACTIVE TEST

ACTIVE TEST

Diagnosis system (bcm) (without intelligent

Diagnosis system (combination meter)

Consult function (meter/m&a) Application items Consult can perform the following diagnosis modes via can communication and the combination meter. Self diag result Refer to mwi-26, " ...

Diagnosis system (bcm) (without intelligent key system)

Common item Common item : consult function (bcm - common item) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. Direct Diagnostic Mode Descripti ...

Other materials:

Exhaust valve timing control
EXHAUST VALVE TIMING CONTROL : System Description SYSTEM DIAGRAM INPUT/OUTPUT SIGNAL CHART Sensor Input signal to ECM ECM function Actuator Crankshaft position sensor (POS) Engine speed and piston position Exhaust valve timing control Exhaust valve timing ...

Adjustment of steering angle sensor neutral position
Description Refer to the table below to determine if adjustment of steering angle sensor neutral position is required. ×: Required вЂ“: Not required Work Procedure ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION CAUTION: To adjust neutral position of steering angle sensor, ...

System description
Component parts Component parts location Instrument lower finisher Component description Eco mode switch The ECO mode switch is installed to the instrument lower finisher. When the eco mode indicator lamp on the combination meter is off and the eco mode switch is pressed, t ...