The illumination control switch is inoperative
Description
If any of the following malfunctions is found for the illumination control
switch operation.
All switches are inopera
The specified switch cannot be operated
Diagnosis procedure
1.Check illumination control switch signal circuit
Check the illumination control switch signal ...
Compression pressure
Inspection
Warm up the engine to full operating temperature.
Release fuel pressure. Refer to EC-143, "Work Procedure".
Remove ignition coil and spark plug from each cylinder. Refer to EM-46,
"Exploded View".
Connect engine tachometer (not required in use of CONSULT). ...
Removal and installation
BCM
Removal and installation
Note:
Before replacing BCM, perform “READ CONFIGURATION” to save or print
current vehicle specification. Refer
to BCS-61, "CONFIGURATION (BCM) : Description".
Removal
Disconnect the negative battery terminal. Refer to pg-52, "removal a ...