Nissan Sentra manuals

Nissan Sentra Service Manual: Removal and installation

Power window lock switch does not function
Diagnosis Procedure 1.REPLACE POWER WINDOW MAIN SWITCH Replace power window main switch. Confirm the operation after replacement. Is the result normal? YES >> INSPECTION END NO >& ...

Main power window and door lock/ unlock switch
Removal and Installation REMOVAL Release the pawls using a suitable tool and lift the main power window and door lock/unlock switch and finisher as an assembly and remove. Disconnect the h ...

Other materials:

P050A, P050B, P050E Cold start control
Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A, P050B or P050E ...

Rear air spoiler
Removal and installation Rear air spoiler High mounted stop lamp connector (if equipped) Trunk lid Grommet Nut Front Removal Remove trunk lid finisher. Refer to INT-45, "Removal and Installation". Disconnect the harness connector from the high mounted stop ...

Symptom diagnosis
Nissan vehicle immobilizer systemnats symptoms Symptom Table Note: Before performing the diagnosis in the following table, check “SEC-171, "Work Flow"”. Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, ...

© 2014-2026 Copyright www.nisentra.com