Nissan Sentra manuals

Nissan Sentra Service Manual: System description

Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Commercial Service Tools ...

Component parts
Component Parts Location ABS actuator and electric unit (control unit) IPDM E/R Brake fluid level switch Front wheel sensor LH (RH similar) Rear wheel sensor LH (RH s ...

Other materials:

Checking bulbs
With all doors closed, apply the parking brake and place the ignition switch in the ON position without starting the engine. The following lights will come on: If equipped, the following lights come on briefly and then go off: If any light fails to come on, it may indicate an open circuit ...

Front door glass
Removal and Installation REMOVAL WARNING: Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes. Do not use air tools or electric tools for servicing. NOTE: LH front door panel shown; RH side similar Disconnect the battery ...

General Precautions
Always use a 12 volt battery as power source. Do not attempt to disconnect battery cables while engine is running. Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF and disconnect negative battery cable. Failure to do so may damage the ECM because ...

В© 2014-2026 Copyright www.nisentra.com