Nissan Sentra Owners Manual: Towing your vehicle

Nissan Sentra Owners Manual / In case of emergency / Towing your vehicle

When towing your vehicle, all State (Provincial in Canada) and local regulations for towing must be followed. Incorrect towing equipment could damage your vehicle. Towing instructions are available from a NISSAN dealer. Local service operators are generally familiar with the applicable laws and procedures for towing. To assure proper towing and to prevent accidental damage to your vehicle, NISSAN recommends having a service operator tow your vehicle. It is advisable to have the service operator carefully read the following precautions:

WARNING

Never ride in a vehicle that is being towed.
Never get under your vehicle after it has been lifted by a tow truck.

CAUTION

When towing, make sure that the transmission, axles, steering system and powertrain are in working condition. If any of these conditions apply, dollies or a flatbed tow truck must be used.
Always attach safety chains before towing.

For information about towing your vehicle behind a recreational vehicle (RV), refer to “Flat towing” in the “Starting and Driving” section of this manual.

If your vehicle overheats

If your vehicle is overheating (indicated by an extremely high temperature gauge reading), or if you feel a lack of engine power, detect abnormal noise, etc., take the following steps. WARN ...

Towing recommended by NISSAN

(CVT) Continuously Variable Transmission (M/T) Manual transmission NISSAN recommends that your vehicle be towed with the driving (front) wheels off the ground or place the vehicle on a f ...

Other materials:

Removal and installation
Nats antenna amp Removal and installation Removal Remove instrument finisher b. Refer to ip-14, "exploded view". Using a suitable tool release the pawls on either side and remove the NATS antenna amp. from the pushbutton ignition switch. Installation Installation is in the ...

Low tire pressure warning lamp does not turn oFF
Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On DIAGNOSTIC PROCEDURE 1.INSPECT BCM CONNECTOR Turn ignition switch OFF. Disconnect BCM connectors. Check terminals for damage or loose connections. Is the inspection result normal? YES >> GO TO 2. NO > ...

Wiring diagram
Eco mode system Wiring Diagram ...