Nissan Sentra Service Manual: Diagnosis system (bcm) (with intelligent key system)

Nissan Sentra Service Manual / Driver controls / Exterior lighting system / System description / Diagnosis system (bcm) (with intelligent key system)

Common item

Common item : consult function (bcm - common item)

Application item

Consult performs the following functions via can communication with bcm.

Direct diagnostic mode	Description
ECU identification	The BCM part number is displayed.
Self diagnostic result	The BCM self diagnostic results are displayed.
Data monitor	The bcm input/output data is displayed in real time.
Active Test	The BCM activates outputs to test components.
Work support	The settings for bcm functions can be changed.
Configuration	The vehicle specification can be read and saved. The vehicle specification can be written when replacing bcm.
CAN DIAG SUPPORT MNTR	The result of transmit/receive diagnosis of can communication is displayed.

System application

Bcm can perform the following functions.

Headlamp

Headlamp

HEADLAMP : CONSULT Function (BCM - HEAD LAMP)

Data monitor

Active test

Active test

Work support

Work support

*: Initial setting

Flasher

Flasher : consult function (bcm - flasher)

Data monitor

Active test

Active test

Work support

Work support

* : Initial setting

System

Headlamp system HEADLAMP SYSTEM : System Diagram HEADLAMP SYSTEM : System Description LOW BEAM OPERATION When the lighting switch is in 2nd position, the BCM receives input requesting the h ...

Diagnosis system (BCM) (without intelligent key system)

Common item COMMON ITEM : CONSULT Function (BCM - COMMON ITEM) Application item Consult performs the following functions via can communication with bcm. Direct diagnostic mode Descriptio ...

Other materials:

P2857 Clutch A Pressure
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P2857 CLUTCH A PRESSURE (Clutch A Pressure Engagement Performance) The auxiliary gearbox gear ratio is 2.232 or more for the auxili ...

Transaxle side
TRANSAXLE SIDE : Removal and Installation Remove boot after drive shaft is removed from the vehicle. For drive shaft removal and installation, follow the instructions bellow. 6M/T: Refer to FAX-18, "6M/T : Removal and Installation (LH)". Except 6M/T: Refer to FAX-26, "EXCEPT ...

CD care and cleaning
Handle a CD by its edges. Do not bend the disc. Never touch the surface of the disc. Always place the discs in the storage case when they are not being used. To clean a disc, wipe the surface from the center to the outer edge using a clean, soft cloth. Do not wipe the disc using ...