Nissan Sentra manuals

Nissan Sentra Service Manual: Wiper & washer

Service data and specifications (SDS)
Bulb Specifications *: Always check with the parts department for the latest parts information. ...

Precaution
...

Other materials:

Abs branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the abs actuator and electric unit (control unit) for damage, bend and loose connection (unit side and connector side). ...

Map lamp
Removal and installation Removal Lower front edge of map lamp (1) down from the headlining by releasing the metal clips, then slide forward to clear pawls at rear. : Metal clip Pawl Disconnect the harness connectors from the map lamp and remove. Installation Installation is in t ...

P050A, P050B, P050E Cold start control
Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A, P050B or P050E ...

В© 2014-2025 Copyright www.nisentra.com