Nissan Sentra Service Manual: EPS Warning lamp

Nissan Sentra Service Manual / Steering / Steering control system / DTC/circuit diagnosis / EPS Warning lamp

Component Function Check

1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP

Check that the EPS warning lamp turns ON when ignition switch turns ON. Then, EPS warning lamp turns OFF after the engine is started.

Is the inspection result normal? YES >> Inspection End.

NO >> Perform trouble diagnosis. Refer to STC-31, "Diagnosis Procedure".

Diagnosis Procedure

1.Perform self-diagnosis

With consult

Turn the ignition switch OFF to ON.
Perform EPS self-diagnosis.

Is any dtc detected? Yes >> check the dtc. Refer to stc-14, "dtc index".

No >> go to 2.

2.CHECK EPS WARNING LAMP SIGNAL

With consult

Turn the ignition switch on.

Caution:

Never start the engine.

Select DATA MONITOR of EPS and select WARNING LAMP.
Check that the EPS warning lamp is turned ON.
Start the engine.

CAUTION:

Never drive the vehicle.

Check that the EPS warning lamp is turned OFF.

Is the inspection result normal? YES >> Perform the trouble diagnosis for combination meter power supply circuit. Refer to MWI-52, "COMBINATION METER : Diagnosis Procedure".

NO >> Replace EPS control unit. Refer to STC-39, "Removal and Installation".

U1000 CAN Comm circuit

Description Can (controller area network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

Symptom diagnosis

...

Other materials:

Precaution for Seat Belt Service
CAUTION: Before removing the seat belt pre-tensioner assembly, turn the ignition switch OFF, disconnect both battery terminals and wait at least three minutes. For approximately three minutes after the battery terminals have been removed, it is still possible for the air bag and seat ...

Replacing
Replace the wiper blades if they are worn. To replace the windshield wiper blades, follow the procedure below: When ignition switch is ON or within 60 seconds after placing the ignition switch from ON to OFF position. Quickly push the windshield wiper and washer lever to the mist pos ...

Removal and installation
Nats antenna amp Removal and installation Removal Remove instrument finisher b. Refer to ip-14, "exploded view". Using a suitable tool release the pawls on either side and remove the NATS antenna amp. from the pushbutton ignition switch. Installation Installation is in the ...