Nissan Sentra manuals

Nissan Sentra Service Manual: Front wiper arm

Exploded View


  1. Wiper blade (RH)
  2. Wiper arm (RH)
  3. Wiper drive assembly
  4. Wiper arm (LH)
  5. Wiper blade (LH)

Removal and Installation

REMOVAL

  1. Remove the wiper arm cap.
  2. Remove the wiper arm nut.
  3. Raise the wiper arm, then remove the wiper arm.

INSTALLATION

  1. Clean the wiper arm mount as shown.

NOTE:

This will reduce the possibility of wiper arm looseness.


  1. Install the wiper arm.
  2. Install the wiper arm nut.
  3. Install the wiper arm cap.
  4. Check that the wiper blades stop at the park position.
Washer nozzle & tube
Exploded view Check valve Washer tube Washer tank Washer pump Washer nozzle Clip Washer nozzle Washer nozzle : removal and installation REMOVAL Disconnect the washer nozzle ...

Wiper blade
Wiper blade WIPER BLADE : Removal and Installation REMOVAL Put the wiper arms in the service position. Turn the ignition switch ON and then OFF. Within 1 minute, activate washer switch 2 ...

Other materials:

C1604 Torque sensor
DTC Logic DTC DETECTION LOGIC DTC Display item Malfunction detected condition Possible cause C1604 TORQUE SENSOR When torque sensor output signal is malfunctioning Harness or connector Torque sensor EPS control unit DTC CONFIRMATION ...

Precaution for Seat Belt Service
CAUTION: Before removing the seat belt pre-tensioner assembly, turn the ignition switch OFF, disconnect both battery terminals and wait at least three minutes. For approximately three minutes after the battery terminals have been removed, it is still possible for the air bag and seat ...

Main power supply and ground circuit
Diagnosis Procedure 1.CHECK TCM POWER CIRCUIT (PART 1) Turn ignition switch OFF. Disconnect TCM connector. Check voltage between TCM harness connector terminals and ground. Is the inspection result normal? YES >> GO TO 2. NO >> GO TO 4. 2.CHECK TCM POWER CIRCUIT (PAR ...

В© 2014-2025 Copyright www.nisentra.com