Nissan Sentra Service Manual: Rear window defogger and door mirror defoggers do not operate
Diagnosis procedure
Regarding Wiring Diagram information, refer to DEF-20, "Wiring Diagram".
1. Check rear window defogger switch
Check rear window defogger switch.
Refer to def-30, "component function check".
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace the malfunctioning parts.
2. Check rear window defogger relay
Check rear window defogger relay.
Refer to def-32, "component function check".
Is the inspection result normal? Yes >> go to 3 .
No >> repair or replace the malfunctioning parts.
3. Check rear window defogger power supply and ground circuit
Check rear window defogger power supply and ground circuit.
Refer to def-33, "component function check".
Is the inspection result normal? Yes >> check intermittent incident. Refer to gi-39, "intermittent incident".
No >> repair or replace the malfunctioning parts.
Defogger system symptoms
Symptom table
*: if equipped ...
Rear window defogger does not operate but both door mirror defoggers operate
Diagnosis procedure
1. Check rear window defogger power supply and ground circuit
Check rear window defogger power supply and ground circuit.
Refer to DEF-32, "Component Function Check" ...
Other materials:
Precautions for Suspension
When installing rubber bushings, the final tightening must be carried
out under unladen conditions with tires
on ground. Spilled oil might shorten the life of rubber bushings. Be sure to
wipe off any spilled oil.
Unladen conditions mean that fuel, engine coolant and lubricant are
...
Symptom diagnosis
Engine does not start when intelligent key is inside of vehicle
Description
Engine does not start when push-button ignition switch is pressed while
carrying intelligent key.
Note:
Check that vehicle is under the condition shown in “conditions of
vehicle” before starting diagnos ...
Bcm branch line circuit
Diagnosis Procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the BCM for damage, bend and loose
connection (unit side and
connector side).
Is the inspection result normal?
YES > ...
