Nissan Sentra Service Manual: Can system (type 1)
Dtc/circuit diagnosis
- Main line between ipdm-e and dlc circuit
- Ecm branch line circuit
- Abs branch line circuit
- Ipdm-e branch line circuit
- A-bag branch line circuit
- Dlc branch line circuit
- Eps branch line circuit
- M&a branch line circuit
- Strg branch line circuit
- Bcm branch line circuit
- Can communication circuit
Dtc/circuit diagnosis
Malfunction area chart
Main line
Branch line
Short circuit
Main line between ipdm-e and dlc circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Discon ...
Main line between ipdm-e and dlc circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and ...
Other materials:
Steering wheel
Exploded View
Driver air bag module
Steering wheel
Steering column assembly
Removal and Installation
REMOVAL
NOTE:
When reconnecting spiral cable, fix cable with a tape so that
fixing case and rotating part keep aligned. This
will omit neutral position alignment procedu ...
Trunk lid release switch
WARNING
Do not drive with the trunk lid open. This
could allow dangerous exhaust gases
to be drawn into the vehicle. See “Exhaust
gas” in the “Starting and driving”
section of this manual.
Closely supervise children when they
are around cars to prevent ...
Throttle valve closed position
learning
Description
Throttle Valve Closed Position Learning is a function of ECM to learn the
fully closed position of the throttle
valve by monitoring the throttle position sensor output signal. It must be
performed each time the harness connector
of the electric throttle control actuator or ECM is ...
