Nissan Sentra Service Manual: CVT: RE0F11A
- Precaution
- Preparation
- System description
- Structure and operation
- System
- Diagnosis system (TCM)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/Circuit diagnosis
- U0140 Lost communication (BCM)
- U0155 Lost communication (IPC)
- U1000 Can comm circuit
- U1117 Lost communication (ABS)
- P062F Eeprom
- P0705 Transmission range sensor A
- P0706 Transmission range sensor A
- P0711 Transmission fluid temperature sensor A
- P0712 Transmission fluid temperature sensor A
- P0713 Transmission fluid temperature sensor A
- P0715 Input speed sensor A
- P0720 Output speed sensor
- P0740 Torque converter
- P0743 Torque converter
- P0744 Torque converter
- P0746 Pressure control solenoid A
- P0846 Transmission fluid pressure SEN/SW B
- P0863 TCM Communication
- P0962 Pressure control solenoid A
- P0963 Pressure control solenoid A
- P0965 Pressure control solenoid B
- P0966 Pressure control solenoid B
- P0967 Pressure control solenoid B
- P0998 Shift solenoid F
- P0999 Shift solenoid F
- P099B Shift solenoid G
- P099C Shift solenoid G
- P1586 G Sensor
- P1588 G Sensor
- P2765 Input speed sensor B
- P2857 Clutch A Pressure
- P2858 Clutch B Pressure
- P2859 Clutch A Pressure
- P285A Clutch B Pressure
- Main power supply and ground circuit
- Overdrive control switch
- Od off indicator lamp
- Shift position indicator circuit
- Shift lock system
Service data and specifications (SDS)
General Specifications
...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE- ...
Other materials:
Moonroof switch
Removal and installation
REMOVAL
Remove the map lamp. Refer to INL-52, "Removal and Installation".
Release the pawls and remove the moonroof switch finisher (1).
: Pawl
Release the pawls and remove the moonroof switch (2).
: Pawl
INSTALLATION
Installation is in the ...
Service data and specifications
Wheel Bearing
Drive Shaft
Drive Shaft Specifications
*: Always check with the Parts Department for the latest parts information.
Dynamic Damper Specifications
...
DTC/Circuit diagnosis
POSITION SWITCH
BACK-UP LAMP SWITCH
BACK-UP LAMP SWITCH : Component Inspection
1.CHECK BACK-UP LAMP SWITCH
Disconnect position switch harness connector. Refer to TM-21, "Removal
and Installation".
Check continuity between position switch terminals.
Is the inspection ...
