Nissan Sentra Service Manual: System
- Engine control system
- Multiport fuel injection system
- Electric ignition system
- Intake valve timing control
- Exhaust valve timing control
- Intake manifold runner control
- Intake manifold tuning system
- Engine protection control at low engine oil pressure
- Fuel filler cap warning system
- Air conditioning cut control
- Cooling fan control
- Starter motor drive control
- Evaporative emission system
- Automatic speed control device (ASCD)
- Can communication
- Eco mode control
- Sport mode control
Structure and operation
Positive Crankcase Ventilation
This system returns blow-by gas to the intake manifold.
The positive crankcase ventilation (PCV) valve is provided to conduct crankcase
blow-by gas to the inta ...
Engine control system
ENGINE CONTROL SYSTEM : System Description
SYSTEM DIAGRAM
NOTE:
Position switch and clutch pedal position switch are not used in
models with CVT.
ASCD steering switch and brake pedal po ...
Other materials:
Rear drum brake
Brake Burnishing
CAUTION:
Burnish contact surfaces between brake drum and brake lining
according to the following procedure
after refinishing or replacing brake drum, or if a soft pedal occurs at very
low mileage.
Be careful of vehicle speed because the brake does not operate
firml ...
Wiring diagram
Ipdm e/r (intelligent power distribution module engine room)
Wiring diagram
...
Fuel-filler cap
WARNING
Gasoline is extremely flammable and
highly explosive under certain conditions.
You could be burned or seriously
injured if it is misused or mishandled.
Always stop the engine and do not
smoke or allow open flames or sparks
near the vehicle when refuelin ...
В© 2014-2026 Copyright www.nisentra.com
